System-board
tray cover
System-board
tray
1. Lower the cover so that the pins at the rear of the cover slide down into the
slots at the rear of the system-board tray. Before you close the cover, make
sure that all components are installed and seated correctly, all internal cables
are correctly routed, and you have not left loose tools or parts inside the
system-board tray.
2. Pivot the cover to the closed position until it clicks into place.
3. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 279).
Removing a GPGPU enclosure
System-board
tray
GPGPU
enclosure
Release
latch
To remove a GPGPU enclosure, complete the following steps:
Chapter 5. Removing and replacing server components
281
Summary of Contents for System x iDataPlex dx360 M4 7912
