Removing a storage enclosure
To remove a storage enclosure from the system-board tray, complete the following
steps:
1. Read the safety information that begins on page v and “Installation guidelines”
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 16).
3. If the system-board tray is installed in a chassis, remove it (see “Removing a
system-board tray from a 2U chassis” on page 19).
4. Carefully set the system-board tray on a flat, static-protective surface.
5. Note the cable routing and connection locations; then, disconnect the cables
that connect the storage enclosure to the system-board tray.
6. Pull the release latch on each side of the system-board tray outward; then,
rotate the storage enclosure open.
7. Using care not to pull on the cables, lift the storage enclosure from the
system-board tray and carefully set it on a flat, static-protective surface.
Chapter 3. Installing optional devices
21
Summary of Contents for System x iDataPlex dx360
