13.
Connect the LED signal, SATA signal and power cables to the hot-swap backplane used for the rear
hard disk drive cage. They can all be found from the option package.
SATA 0 connector
LED signal
connector
Power connector
SATA 1 connector
14.
Align the backplane with the slot on the optional rear hard disk drive cage.
15.
Lower the backplane into the optional rear hard disk drive cage. Make sure the three alignment pins
securely engages the three holes on the hard disk drive cage.
SAS/SATA
backplane
Hard disk
drive cage
Alignment pins
16.
Connect the other end of the LED signal cable to the hot-swap hard disk drive backplane in the
server.
17.
Find the rear hard disk drive detect pin of the hot-swap backplane signal (I
2
C) cable located near the
system fan cage; then, connect with the rear hard disk drive detect pin of the LED signal cable from
the option package.
4