Command
Function
&V1
Display Last Connection Statistics
&W_
&W0
Stores the active profile as Profile 0
&W1
Stores the active profile as Profile 1
%E_
%E0
Disable auto-retrain
%E1
Enable auto-retrain
+MS?
Displays the current Select Modulation
settings
+MS=?
Displays a list of supported Select Modulation
options
+MS=a,b,c,e,f
Select modulation where:
a
=0, 1, 2, 3, 9, 10, 11,
12, 56, 64, 69;
b
=0-1;
c
=300-56000;
d
=300-
56000;
e
=0-1; and
f
=0-1.
A, b, c, d, e, f
default=
12, 1, 300, 56000, 0, 0.
Parameter
″
a
″
specifies the modulation protocol desired
where: 0=V.21, 1=V.22, 2=V.22bis, 3=V.23,
9=V.32, 10=V.32bis, 11=V.34,
12=V.90,K56Flex,V.34......,56=K 56Flex,
V.90,V.34......, 64=Bell 103, and 69=Bell 212.
Parameter
″
b
″
specifies automode operations
where: 0=automode disabled, 1= automode
enabled with V.8/V.32 Annex A. Parameter
″
c
″
specifies the minimum connection data rate
(300- 56000). Parameter
″
d
″
specifies the
maximum connection rate (300-56000);
Parameter
″
e
″
specifies the codec type (0=
Law, and 1=A-Law). Parameter
″
f
″
specifies
″
robbed bit
″
signaling detection (0=detection
disabled 1=detection enabled)
MNP/V.42/V.42bis/V.44 commands
Command
Function
%C_
%C0
Disable MNP Class 5 and V.42bis data compression
%C1
Enable MNP Class 5 data compression only
%C2
Enable V.42bis data compression only
%C3
Enable MNP Class 5 and V.42bis data compression
&Q_
&Q0
Direct data link only (same as \N1)
&Q5
V.42 data link with fallback options
&Q6
Normal data link only (same as \N0)
+DS44=0, 0
Disable V.44
+DS44=3, 0
Enable V.44
+DS44?
Current values
+DS44=?
List of support values
104
User Guide
Summary of Contents for ThinkCentre A30 8198
