When both the power-on password and the
supervisor password are set.
1. Turn off the computer.
2. Turn the computer upside down, loosen the
memory-slot cover screw
.1/
, remove the
memory-slot cover
.2/
.
3. Short the two password jumper pads on the
system board (see
.3/
of the previous page).
4. Turn on the computer. After a few seconds, the
password prompt appears.
5. Enter the supervisor password. The
“Easy-setup main menu” appears.
6. Select Password and then Power on. A
rectangular box appears.
7. Enter the supervisor password and press the
Space bar once.
8. Press Enter twice.
9. Select Exit.
10. Select Restart in the “Easy-setup main menu”
and wait until the POST ends.
11. Reinstall the memory-slot cover, and turn the
computer right side up.
Verify that the password prompt does not appear.
To reactivate the password, set the password again.
Power Shutdown Switch:
The power shutdown
switch resets the system regardless of the microcode
status and forces a power off. Use this push button to
power off when power is not completely off or when the
microcode is in a hung state.
22
IBM ThinkPad 380XD, 385XD
Summary of Contents for ThinkPad 380XD
