Starting DOS
To start up DOS from the additional hard disk in the Dock II, you
must change the startup sequence.
Important
To start up DOS from a SCSI drive, set the SCSI ID of the drive to
0. You cannot start up DOS from drives with SCSI IDs other than
0.
To change the startup sequence, do the following.
1.
Install the additional hard disk
in the Dock II.
2.
Check the devices you have
installed or attached.
Then assign serial numbers (1
through 4) only to the hard disk
devices you have checked, from
the top to the bottom of the first
table.
Then assign serial numbers (1
through 2) to the diskette
drives.
The second table shows an
example of a completed table.
ThinkPad Hard Disk in the computer
Diskette Drive in the computer
Hard Disk/Diskette Drive
Drive
Number
SCSI Hard Disk (SCSI ID Number 0)
ThinkPad Hard Disk in the Dock II
or IDE Hard Disk
Diskette Drive connected to the Dock II
106
IBM ThinkPad Dock II User's Guide
Title: C78JAMST CreationDate: 05/06/94 19:15:58
All manuals and user guides at all-guides.com
