The kit includes a
DS Storage Manager Support
CD that has the appropriate
IBM DS Storage Manager host software. If you order more than one host
software kit, the additional kits may also be shipped in the DS5100 and
DS5300 shipping box.
The CD also includes the DS Storage Subsystem controller firmware.
Controller firmware can be downloaded from the IBM support Web site for
DS5100 and DS5300 storage products:
www.ibm.com/systems/support/storage/disk
Note:
Depending on your DS5100 and DS5300 model, you may need to
purchase the appropriate host software kit for your host server
operating system. Contact your IBM representative or reseller for more
information.
5. Continue with “Preparing the site.”
Preparing the site
This section lists the floor space requirements and weight information for the
storage subsystem. For information on interface cables and connections, see
Chapter 3, “Cabling the storage subsystem,” on page 47.
Floor space:
The floor area at the installation site must provide the following
conditions:
v
Sufficient space to install the storage subsystem
v
Enough stability to support the weight of the fully configured storage subsystem
and associated systems.
Ensure that all requirements, such as floor space, air conditioning, and electrical
service, have been met. Other site preparation activities include the following tasks:
v
To ensure that there is enough room to move around the cabinet and install
modules, clear space at the installation area.
v
Install uninterruptible power supply (UPS) devices.
v
If applicable, install host servers with fibre channel host bus adapters (HBAs),
fibre channel switches, or other devices.
v
Route interface cables from the fibre channel HBA ports in the hosts or fibre
channel switches to the installation area.
v
Route main power cords to the installation area.
Continue with “Preparing the rack cabinet.”
Preparing the rack cabinet
Important:
Before you install the storage subsystem in a rack cabinet, keep in mind
the following considerations:
v
Review the documentation that comes with your rack enclosure for safety and
cabling considerations.
v
If you are using a non-IBM rack or cabinet, review the information in Appendix D,
“Specifications for non-IBM rack installation,” on page 229.
v
Do not extend more than one device out of the rack cabinet at the same time.
v
Install the storage subsystem in a 22° C (72° F) environment. See
“Environmental requirements and specifications” on page 26 for details.
v
To ensure proper airflow, do not block the air vents; ensure at least 15 cm (6 in.)
of air space.
Chapter 2. Installing the storage subsystem
37
