Connecting an LC-SC cable adapter to a device
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v
Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Complete the following steps to connect an LC-SC fibre-channel cable adapter to a
device:
1. Read the information in “Handling fibre-optic cables” on page 48.
2. Connect one end of an LC-LC cable to an SFP module in the DS5100 and
DS5300. For instructions, see “Using LC-LC fibre-channel cables” on page 53.
3. Remove the two protective caps from the LC connector end of the LC-SC cable
adapter as shown in Figure 31. Save the protective caps for future use.
4. Carefully insert the other end of the LC-LC cable into the LC connector end of
the LC-SC cable adapter as shown in Figure 32 on page 59. Push in the
f10ug013
Figure 31. Removing the LC-SC cable adapter protective caps
58
IBM System Storage DS5100 and DS5300 Storage Subsystem: Installation, User’s, and Maintenance Guide