source is good and the power supplies can 5 V dc current to the engine.
This feature helps isolate the problem if an error causes the engine to shut down.
Figure 8 shows the LEDs on the diagnostics panel.
Note:
You might have to remove the cover to view these LEDs. (For more
information on removing the cover, refer to “Removing the cover” in Chapter
3 of the hardware installation guide). See Table 22 on page 130 for more
information on the LEDs.
1
CPU LED
2
VRM LED
3
Memory LED
4
PCI Bus LED
5
Power supply 1 LED
6
Power supply 2 LED
7
Fan LED
8
Remind button
9
DASD LED
10
NMI LED
11
Service Processor Bus LED
12
Nonredundant LED
13
Temperature LED
POST
When you power on the NAS Gateway 300, it performs a series of tests to check
the operation of its components and some of the options installed in the NAS
Gateway 300. This series of tests is called the power-on self-test (POST).
One beep after the POST completes successfully indicates that the NAS Gateway
300 is operating correctly.
CPU
VRM
MEMORY
DASD
NMI
SERVICE
PROCESSOR BUS
FAN
POWER SUPPLY
PCI BUS
2
1
NONREDUNDANT
TEMPERATURE
REMIND
8
1
2
3
4
5
6
7
9
11
12
10
13
Figure 8. LED diagnostics panel
Chapter 8. Troubleshooting
91
Summary of Contents for TotalStorage NAS 300
