18
IBM WorkPad z50, Mobile Companion 18
7.
With the notched end of the card toward the right side
of the socket, insert the card at an angle of
approximately 20 degrees into the socket; press it in
firmly as shown (1). Gently pivot the card until it snaps
into place (2).
Attention
To avoid damaging the ROM/DRAM card, do not touch its
contact edge.
8.
Ensure that the ROM/DRAM card is securely inserted in
the slot.
9.
Replace the ROM/DRAM card cover over the memory
slot, aligning the back side of the cover first; then
tighten the screw.
10. Attach the main battery and insert the backup batteries.
11. Turn the WorkPad z50 top side up. Connect the AC
Adapter and cables; then turn on the WorkPad z50.
Attention
Handling a Screwdriver
•
Use a screwdriver that fits the screw.
•
Use the screwdriver perpendicular to the head of the
screw.
Handle the screwdriver properly; otherwise, you might
damage the screw.
Removing the ROM/DRAM Card
Note: Before removing the ROM/DRAM card, back up all
data and applications in the base memory. All data and
installed applications will be lost by removing the
ROM/DRAM card. The ROM needs to be reinstalled before
starting the POST or running Windows CE.
Caution: Before removing the ROM/DRAM card, all power
sources (AC power, the main battery pack, and the backup
batteries) must be removed.
Follow these instructions when removing the ROM/DRAM
card:
1.
Turn off the WorkPad z50.
2.
Disconnect AC power.
3.
Turn the WorkPad z50 upside down.
4.
Remove the main battery and remove the backup
batteries.
