Information capture. Done right
™
866-798-4265
www.ibml.com
10
5. Once the system is unpacked, remove the front frame covers by pulling the black latch on each cover to release the top of the cover. For each
frame, pull the cover forward and lift it off. Set the covers off to the side until the installation is complete.
6. Locate the two hex screws at the top of each of the rear cover. Using a 4mm hex wrench (included in the over pack box), loosen the hex screws and
then remove each rear frame cover. Set the covers off to the side until the installation is complete.
4mm Hex Wrench
7. Move the individual frames into the location where the machine will operate and place the frames in the correct order.
Ensure that no cables are pinched between the frames as they are brought together.
The individual frames are designed to fit through normal size door openings, prior to assembly. The machine will roll once it is fully assembled;
however, it is advisable to move the individual frames into position rather than move the entire machine.
