Operating Instructions IBS-Parts Cleaner Type BK 50 (IW/V4.0/10-2012/EN)
Page
4
1. About the Machine / Technical Data _________________
Dimensions and Performance Data
Type BK 50
External dimension device:
Length:
656
mm
Width:
475
mm
Height:
1075
mm
Working Area (inside dimension):
646 x 465 mm
Working height:
815 mm
Weight without drum:
15 kg
Weight with drum (full)
60 kg
Bearing capacity:
50 kg
Fill volume:
50 l
Noise emission value
at work station:
< 70 dB (A)
Type class (according to EN 12921-3)
A1
Electrical Connection
Power supply:
1/N/PE 230 V ~
Frequency:
50
Hz
Power draw:
45 W – 0,2 A
Max. back-up fuse
6 A
Pneumatic Conntection (Option)
Pressure:
max. 4 bar
Pressure connection:
1/8“
2. Proper use and foreseeable misuse __________________
The IBS-Parts Cleaner Type BK 50 has been designed for cleaning oily and greasy metal parts (e.g.
machine parts, motors and housings) using IBS-Special Cleaners.
2.1.
Approved Solvents
Solvents used with this machine must not contain halogenated hydrocarbons and must meet
the following requirements:
Device Type BK 50:
IBS Special Cleaner Type EL/Extra
IBS
Special
Cleaner
Type
RF
IBS
Special
Cleaner
Type
Purgasol
NOTICE
Please pay attention to the solvent´s corresponding product information (EC Safety
Data Sheet), before using solvents by other manufacturers. Prove in particular the
compliance of the respective exposure limit value.
Please take advice from IBS Scherer GmbH. Please also note additionally the notes
under 2.2!
The extended warranty of 3 applies only if IBS Special Cleaners are used.
2.2.
Non-Approved Solvents
The use of highly inflammable and inflammable liquids inside this machine is prohibited.
The introduction of liquids with a flash point < 55°C, such as motor gasoline, is
prohibited.
DANGER
Please observe any relevant local and national legal requirements concerning the use of solvents for
parts cleaning.
