Motherboard Information
SE-102-N User Manual
9
2
2.1 Installations
Before installing any card or module into the device, remove the 11 screws
shown in the picture below. Pull out the u-shaped side frame and then remove
the bottom cover.
2.1.1
Memory Module Installation
To install or replace modules, locate the memory slot on the board and
perform the following steps:
1. Align the key of the memory module with that on the memory slot and
insert the module slantwise.
2. Gently push the module in an upright position until the clips of the slot
close to hold the module in place when the module touches the bottom of
the slot.
To remove a module, use your fingers to press the clips outwards until the
module pops up. Grab the module gently and pull it out of the slot.
