To use telnet configuration
establish a telnet session to the LinkHub-E on port 9999.
Press Enter for setup mode.
Under Change Setup enter 1 for Channel 1
At Baudrate (xxxx)? enter 115200
Hit return to accept the current values until DisConnMode appears
At DisConnMode (00) ? enter 40
Hit Return to accept the current values until Change Setup appears again, then enter 9 for
Save and Exit
Telnet configuration example:
telnet 192.168.0.2 9999
MAC address 00204A9A66B1
Software version V6.5.0.7 (070919) XPTEXE
Press Enter for Setup Mode
*** basic parameters
Hardware: Ethernet TPI
IP addr 192.168.0.2, gateway 192.168.0.1,netmask 255.255.255.0
*** Security
SNMP is enabled
SNMP Community Name: public
Telnet Setup is enabled
TFTP Download is enabled
Port 77FEh is enabled
Web Server is enabled
Web Setup is enabled
ECHO is disabled
Enhanced Password is disabled
Port 77F0h is enabled
*** Channel 1
Baudrate 115200, I/F Mode 4C, Flow 00
Port 10001
Connect Mode : C0
Send '+++' in Modem Mode enabled
Show IP addr after 'RING' enabled
Auto increment source port disabled
Remote IP Adr: --- none ---, Port 00000
Disconn Mode : 40 (Telnet Com Port Cntrl Enabled)
Flush Mode : 00
Terminal name:
*** Expert
TCP Keepalive : 45s
ARP cache timeout: 600s
CPU performance: Regular
Monitor Mode @ bootup : enabled
Copyright © 2008 by iButtonLink LLC
iButton and 1-Wire are trademarks of Dallas Semiconductor Corp, Dallas, Texas, USA.
15 of 17
