Power amplifier - Settings
The power amplifier have three different input
sensitivity settings. You can select the sensitivity with
the jumper SW 401.
(1V, 500mV und 100mV)
AMP 120/240/480
20
EN
100mV
500mV
SW401
SW403
print board
JP1
JP2
SW404
1V
Power amplifier-settings
Stand alone (default setting)
double - oder treble operating
For the stand alone operation with the power
amplifier, select the jumper (SW403 and SW404) of
the print board to the “STAND ALONE” Position.
For the double or treble operation define power
amplifier as an MASTER - UNIT. Select the jumper to
the MASTER position (look at the draft). All further
power amplifiers will adjust with the jumper “SLAVE”.
(Look at the draft)
The power amplifier have three different input
sensitivity settings. You can select the sensitivity with
the jumper SW 401.
(1V, 500mV und 100mV)
SW403
SW404
Stand Alone
Master
Slave
ic audio
Circuit Board Fuse
If the amplifier isn’t working, please check the outside
fuse on the rear panel or the inside one.
Further
Information