Passenger Control
When the RED warning lights are activated and the stop arm
is deployed, the alternating
Stop – Do Not Pass
LED message
flashes. See the description of the Eight-Lamp AMBER and RED
warning lights below.
Eight-Lamp AMBER and RED Warning Lights
The eight lamp AMBER and RED warning system is made up of
four AMBER (two front and two rear), and four RED (two front
and two rear) flashing lights, and is part of the warning flasher
system.
The AMBER warning lights alert the public of the intent to stop
and load / unload students onto / from the bus. The RED warning
lights and the stop arm are intended to warn the public that
students are boarding or leaving the bus.
The warning indicator control is located on the right side of the
steering wheel.
Optional Rocker Switches
NOTE: These switches can be located on the left or right
console switch panel.
NOTE: These rocker switches are an optional alternative to
the steering wheel controls. When this option is chosen,
the cruise / throttle switches move to the steering wheel
location.
70
Summary of Contents for BE Series
