11
will properly operate. To manually learn the
tach setting:
1. Press and hold the brake pedal.
2. Start the vehicle with the key then put
the tranmission into reverse gear to
lower the RPMs.
3. Press and release the valet switch, then
press again and hold for 5 seconds.
• The lights will flash and horn will honk
2 times to confirm tach learning.
• If the tach wire is not connected, the
lights will flash and horn will honk 4
times to confirm tachless learning.
4. Manual learning is complete.
If the vehicle still does not start after remote
start activation, the parking lights will flash a
diagnostic code to indicate the problem. See
Remote Start Diagnostic Indications
below.
REMOTE START
DIAGNOSTIC
INDICATIONS
If the remote starter does not activate and attempt to start the vehicle when the start button is
pressed, the parking lights and LED will flash a diagnostic code to identify the problem.
Parking Light
LED Indication
Problem
3 Slow Flashes
On Solid
System in Valet Mode
5 Slow Flashes
5 Flashes
Key is on during remote start attempt
5 Flashes
5 Flashes
Hood is open during remote start attempt
6 Flashes
6 Flashes
Brake pedal is pressed during remote start attempt
7 Flashes
7 Flashes
Tachometer lock out (see dealer)
8 Flashes
8 Flashes
System made 3 attempts to start without success
DIAGNOSTIC EVENT
MEMORY
In case the remote start cranks but fails to start and stay running or shuts down prematurely, a diag-
nostic event is created and stored in memory. The last four diagnostic memory events may recalled
by turning the ignition on and off, then pressing the valet switch once. The parking lights will flash 3
times and the horn will honk (if installed) the same number of times as the number of events in mem-
ory (up to 4). If the horn does not honk, there are no events stored.
Press the valet switch once to check the last diagnostic code. The horn will honk to indicate the first
code and the LED will flash a number of times equal to the shutdown code. Continue this procedure
to view up to 4 events.
Once the diagnostic memory is full it must be cleared by pressing the valet switch for 5 seconds while
in the diagnostic memory mode. The parking lights will flash and horn will honk once to indicate the
memory is cleared.
LED Indication
Cause
5 Flashes
System shutdown by brake switch
6 Flashes
System shutdown by hood pin switch
7 Flashes
System did not detect tach signal
8 Flashes
System made 3 attempts to start without success
RS160manualRev3:BW2450.qxd 1/7/2010 2:24 PM Page 11
Summary of Contents for RS160
Page 14: ...14 NOTES ...
