12
ADDING TRANSMITTERS
To add a new transmitter to the system have
the desired transmitters ready and follow
the Code Learning sequence.
To enter Code Learning Mode:
1. Within 3 seconds, turn the ignition on,
off, on, off and leave on.
2. Press and hold the Valet switch.
• The parking lights will turn on.
• The horn will honk once (optional).
3. Continue to hold the Valet switch.
• The parking lights will turn off.
• The horn will honk 5 times (optional).
4. Release the Valet switch.
5. Press Button 1 on the transmitter.
• The parking lights will flash and horn
will honk (optional).
6. Repeat step 5 for each additional trans-
mitter, up to four total transmitters.
7. Turn off the ignition.
NOTE: If a transmitter is lost or stolen, make
sure to code all 4 transmitter memory loca-
tions. (Example: If only one transmitter is used,
repeat step 3 three more times to remove any
previously programmed transmitters.)
RS160manualRev3:BW2450.qxd 1/7/2010 2:24 PM Page 12
Summary of Contents for RS160
Page 14: ...14 NOTES ...
