IC Dynamics RS160, User Manual

2

• The doors unlock.*

†

• The dome light turns on.*
• The LED stops flashing.

*

Optional Feature

†

If the optional Passenger Unlock Feature is installed,
pressing button 2 unlocks the driver's door. Pressing
button 2 again within 3 seconds unlocks all doors.

SILENT LOCKING/UNLOCKING

If the optional Horn Honk feature is installed,
pressing transmitter buttons 1&2 provides
one-time silent operation.  The system locks
or unlocks without horn confirmation.

IGNITION CONTROLLED LOCKS

The ignition controlled locks feature auto-
matically locks the doors after turning on the
ignition, and unlocks when the ignition key is
turned off.  This feature may also be pro-
grammed for ignition lock without ignition
unlock, and off (no ignition control).

REMOTE PANIC*

In the event of an emergency, the horn can
be triggered for 60 seconds to attract atten-
tion. To activate the Panic Feature, press
transmitter Button 1 for 3 seconds:  

• The horn honks.*
• The parking lights flash.*  

Press button 1 or 2 to exit panic mode. Panic
will not operate when the ignition is on.

*

Optional Feature

AUXILIARY OUTPUT 

To activate the system’s auxiliary output
(trunk release feature) press button 3 for
three seconds. The doors will unlock and the
trunk release (or other option) will open.  

AUXILIARY 2 OUTPUT

To activate the auxiliary 2 output press but-
ton 2 for three seconds.  The doors will
unlock and the auxiliary 2 function will acti-

vate. If button 2 is held, the output will
remain on for up to 5 seconds to close
power sliding doors, etc.

CAR LOCATOR FEATURE

If the system’s trunk release output is not
being used, button 3 may be programmed to
activate the system’s car locator feature. 
To activate the car locator feature press and
hold button 3 for three seconds.

• The parking lights will flash 5 times.
• The horn will honk 5 times.

VALET MODE

Placing the system into Valet Mode disables
the remote start feature. However, the
optional keyless entry and trunk release fea-
tures still function if installed. 
To enter valet mode:

1. Be sure the system is in unlock mode.
2. Turn ignition on.
3. Press and hold the valet switch for 5

seconds.
• The LED turns on solid 5 seconds

after turning ignition off. 

• The horn honks 5 times.

4. Turn ignition off.

To exit valet mode:

1. Be sure the system is in unlock mode.
2. Turn ignition on.
3. Press and hold the valet switch for 5

seconds.
• The LED turns off. 
• The horn honks twice.

4. Turn ignition off.

REMOTE START FEATURES

Important: Only start the vehicle in a well
ventilated area. Do not use in a closed
garage. Be sure to familiarize yourself with all
features prior to using the remote start.

RS160manualRev3:BW2450.qxd  1/7/2010  2:24 PM  Page 2