3
REMOTE STARTING THE VEHICLE
To remote start the vehicle press button 4.
• The parking lights flash once.
• The horn honks once.
• The system cranks the starter.
• Once the car has started, the heater or
air conditioner turns on and runs for
the pre-programmed time. If the engine
fails to start on the first attempt, it will
attempt to start 2 more times. If the
vehicle fails to start after a total of 3
times the system will shut down.
• The parking lights turn on while the
remote start is running.
To drive the vehicle after Remote Starting:
Unlock the door by pressing button 2.
Enter vehicle, turn ignition key on and then
press the brake pedal
NOTE: Do not turn the key to the start posi-
tion as the engine is already running.
If brake pedal is pressed prior to turning on
ignition, engine will turn off.
To add additional run time while the vehicle
is remote started, press button 4 and the
remote start run timer will begin again.
REMOTE ENGINE SHUTDOWN
Press and hold button 4 for 3 seconds to
shut down the remote start.
STOP AND GO
The Stop and Go feature allows the vehicle
to remain running without use of the ignition
key during short stops.
To activate the Stop and Go feature:
1. Make sure the engine is running.
2. Press button 4.
3. Turn ignition off and remove key.
• The doors will unlock.
• The parking lights will turn on.
• The engine will remain running.
To resume driver control:
1. Turn on the ignition.
2. Press the brake pedal.
• The remote start disengages.
TURBO TIMER MODE
The turbo timer feature can run the engine
at idle for an additional 2 minutes after the
ignition is turned off, allowing turbo-charged
engines proper time to cool down, thereby
extending the life of the turbo charger.
To activate the Turbo Timer feature:
1. Make sure the engine is running.
2. Press button 3.
• The horn will honk twice.
• The doors will unlock.
• The parking lights will turn on.
3. Turn ignition off.
• The engine will continue to run 2
minutes.
4. Exit the vehicle.
AUTO COLD START
This feature allows the system to start and
run the vehicle every 2, 3, or 4 hours (user
selectable) for up to 12 starts. This allows the
engine to remain at an operational tempera-
ture in extremely cold weather.
Engaging the Auto Cold Start feature:
1. Press and hold buttons 2 & 4 together
for 3 seconds.
• The parking lights turn on for 10 sec-
onds to enter cycle programming.
2. Press the button corresponding to the
desired start cycle interval:
Button 2 = start every 2 hours
Button 3 = start every 4 hours
Button 4 = start every 3 hours
• The parking lights flash a number
of times equal to the interval.
RS160manualRev3:BW2450.qxd 1/7/2010 2:24 PM Page 3
Summary of Contents for RS160
Page 14: ...14 NOTES ...