IC Dynamics RS160, User Manual

8

which then allows button 3 (normally used
for Auxiliary 1) to be used for the optional
Car Locator feature 

(see Page 2

).  The second

option is for use as a negative (-) Starter out-
put for the Remote Start function which
then allows button 3 to be used for the
optional Car Locator feature. The default
setting is for Auxiliary 1 output which is acti-
vated by pressing button 3. 
6. Auxiliary 2 Output. This output can be
programmed for one of three different oper-
ations.  It may be used as a dome light out-
put, a passenger unlock output, or as a sec-
ond auxiliary output (default).

Menu 2 

1. Valet Mode Timing. Sets the length of time
the valet switch must be held in order to
enter  the valet mode- 15 or 5 seconds. 
2. Parking Light Output.  Sets the parking
light output to turn on for 30 seconds with
unlock or just flash twice with unlock.
3. Horn Honk Pulse Length. Some vehicle
horns may require a longer or shorter pulse
to provide the best horn operation.  The
pulse can be set for 5ms, 15ms, or 10ms.

Menu 3

1. Tach Settings. There are two programming

PROGRAMMABLE FEATURES

(default settings in bold)

Feature

Setting 1

Setting 2

Setting 3

Menu 1

1. Ignition L/UL

On/On

On/Off

Off/Off

2.  Horn Output

Silent L/UL

Normal

3.  Door L/UL Pulses

L / UL x 2

L x 2 / UL

L / UL

4.  Door Pulse Timing 

.25 second

3 seconds 

.75 second

5.  Aux 1 Program

(-) Accessory 

(-) Starter

Auxiliary

6. Aux 2 Program

Dome Light

Passenger UL

Auxiliary 2

Menu 2

1. Valet Mode Timing

Hold 15 seconds

Hold 5 seconds

2.  Parking Light Output

30 seconds w/UL

Flash 2x w/UL

3.  Horn Honk Pulse

5ms (short)

15ms (long)

10ms (normal)

Menu 3

1. Tach Settings

Hybrid Car 1

Hybrid Car 2

Auto Tach/Tachless

2. Over-Crank Adj

Decrease 10%

3. Under-Crank Adj

Increase 10%

4. Tach  Check Wait

300ms Tach  Delay

750ms Tach  Delay

No Tach  Delay

Menu 4

1. Ignition 2 Relay

2nd Starter

2nd Accessory

2nd Ignition

2.  Lock Control w/ Start  UL before/L after Start  L after shutdown only

Normal L/UL pulses

3. Engine Type

(-) Glow/20 sec timer

Start w/ input wire

Gasoline/(+) Glow

4. Factory Alarm Rearm  With Lock only

After start only

After stop & w/L

5. Engine Run Time

4 minutes

45 minutes

15 minutes

6.  Start Button

Press twice to Start

Press once to Start

7. LED Function 

No flash w/Locked

Flash w/Locked

RS160manualRev3:BW2450.qxd  1/7/2010  2:24 PM  Page 8