82
5.5.3 PTZ
Please note only some series products support this function.
The PTZ interface is shown as in
Figure 5-
70.
Figure 5- 70
Please refer to the following sheet for detailed information.
Parameter Function
Protocol
Select the corresponding dome protocol.
Address
Set corresponding dome address. Default value is 1.
Please note your setup here shall comply with your dome address;
otherwise you can not control the speed dome.
Baud
Rate
Select the dome baud rate. Default setup is 9600.
Data Bit
Default setup is 8.
Stop bit
Default setup is 1.
Parity
Default setup is none.
5.5.4 Default
The default setup interface is shown as in
Figure 5-
71.
Please note system cannot restore some information such as network IP address.
Summary of Contents for ICIPD4002IR28
Page 1: ...i Network Camera Web3 0 Operation Manual Version 1 1 0F ...
Page 9: ...5 Figure 1 7 ...
Page 42: ...38 Figure 5 10 Figure 5 11 ...
Page 64: ...60 Figure 5 37 Figure 5 38 ...
