21
3
Installation
3.1
Lens Installation
3.1.1 Auto Aperture Lens
Please follow the steps listed below for auto aperture lens installation. The interface is shown as
in Figure 3-1 and Figure 3-2.
z
Remove the CCD protection cap of the device, and then line up the lens to the proper
installation position. Turn clockwise until the lens is fixed firmly.
z
Insert the lens cable socket to the auto lens connector in the side panel.
Figure 3-1
3.1.2 Manual Lens
Install C type lens
z
Remove the CCD protection cap from the device.
z
Install the C/CS adapter to the camera. Turn clockwise to secure against the focusing ring
firmly.
z
Line up the C lens to the installation position of the C/CS adapter. Turn clockwise to fix the
lens.
z
Use slotted screwdriver to fasten the screw near the focusing ring and then turn counter
clockwise to move the focusing ring out for several millimeters. Now you can focus manually
and check the video is clear or not. If you can not see the clear video, you can adjust via the
flange-back.
z
After you completed the focus setup, use the slotted screwdriver to fix the screw firmly.
Fasten the focusing ring. Now the installation completed.
Install CS type lens
z
Remove the CCD protection cap from the device.
z
Line up the CS lens to the lens installation position of camera focusing ring. Turn clockwise
to fix the lens.
z
Use slotted screwdriver to fasten the screw near the focusing ring and then turn counter
clockwise to move the focusing ring out for several millimeters. Now you can focus manually
and check the video is clear or not. If you can not see the clear video, you can adjust via the
flange-back.
z
After you completed the focus setup, use the slotted screwdriver to fix the screw firmly.
Fasten the focusing ring. Now the installation completed.