2B. RESTORE FACTORY DEFAULTS/ INSTALL SD CARD
Important:
Make sure the device is powered when attempting to press
RESET button.
Step 1
Use the supplied hex wrench to unscrew the access panel
below the camera. Skip to Step 3 if only installing SD card.
Step 2
Slightly press the RESET button for 15-30 seconds to
complete the reset function. See Figure 2-10. The camera will reboot
when the reset process is complete.
MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
5
|
www.icrealtime.com
Figure 2-10
Step 3 (If installing SD Card)
Adjust the Micro SD Card to a proper
direction shown in Figure 2-10.
Step 5
Close the access panel, tighten down locking screw and
reinstall camera.
Figure 3-1
3A. OVERVIEW
The IP Config tool is used to search the local network for IC Realtime
devices as well as modify the IP addresses and upgrading firmware.
This software can be downloaded at:
https://icrealtime.com/downloads
under Desktop Utility Apps
3B. OPERATION
Double click the “ConfigTools.exe” icon to run. The interface will be
displayed as shown in Figure 3-1. Click on the blue circle icon with
the two arrows to refresh and scan the network.
