VI. START UP UPS / MENGHIDUPKAN UPS
1.
Make sure Main Switch on the “off” position
and no load is connected to the outlet.
2.
Connect inlet with power cord to a power
receptacle with earth ground
3.
Turn on the UPS by pressing power button.
The red led of BATTERY LOW lights for about 2
seconds and will go out when the battery is in
good condition
.
At the same time the green led of
LINE ON light (if line voltage > 175V and <
250V) which indicates UPS output is from line
power.
4.
Disconnect inlet from line power, the green led
of LINE ON will go out while the yellow led of
INVERTER will light on and audible alarm will
sound every 4 seconds.
5.
Connect inlet to line power again and then after
about 2 seconds the yellow led of INVERTER
will go out while the green led of line on will
light on.
6.
Now your UPS is ready for operation. Connect
the equipment that is going to be supplied by the
UPS into the UPS.
1.
Pastikan tombol pada posisi “off” dan tidak ada
beban yang terpasang pada stopkontak keluaran.
2.
Hubungkan steker kabel daya ke stopkontak
jala-jala yang mempunyai arde.
3.
Hidupkan UPS dengan menekan tombol daya. Led
merah TEGANGAN BATERAI RENDAH akan
menyala sekitar 2 detik dan padam kembali bila
kondisi baterai baik. Bersamaan dengan itu led
hijau LISTRIK JALA-JALA menyala (bila
tegangannya > 175V dan < 250V) yang
menunjukkan keluaran UPS berasal dari listrik
jala-jala.
4.
Cabut steker kabel daya dari stopkontak jala-jala
maka led hijau LISTRIK JALA-JALA padam
sedangkan led kuning INVERTER akan menyala
dan buzzer akan berbunyi setiap 4 detik.
5.
Pasang kembali steker maka sekitar 2 detik
kemudian led kuning INVERTER padam
sedangkan led hijau akan menyala.
6.
Sekarang UPS siap menjalankan fungsinya.
Hubungkan peralatan yang akan diberi pasokan
daya pada stopkontak keluaran UPS
VII. TABLE OF STATUS INDICATOR / TABEL STATUS INDIKATOR
Remark :
L1 : Green Led (Line On)
NTPL : Audible alarm sound every 4 seconds.
L2 : Yellow Led (Inverter)
NTPC : Audible alarm sound every 1 second.
L3 : Red Led (Battery Low)
BUZZER LED
STATUS
CONDITION
MAIN
SWITCH
NTPL NTPC L1 L2 L3
RECOMMENDED
SOLUTION
Normal
1
0
0 1 0 0
-
No
line
voltage
1
1
0 0 1 0
-
Line voltage too low
1
1
0
0
1
0
Check the line power, make sure
between 175 -250 Vac.
Line voltage too high
1
1
0
0
1
0 Check the line power, < 250 Vac.
Inverter is on at low
battery voltage
1
0
1 0 1 1
Save your work now, the inverter
will be cut off.
1. Line power is
normal.
2. Low battery.
1
0
0 1 0 1
-
Summary of Contents for ce 1200
Page 1: ...ICA ...
