Please make sure you have properly
installed Network Camera lens and
connected to network (12 VDC).
20
Set PC IP address in the same network
segment of the Network Camera factory
default setup.
Such as PC IP Address
is192.168.xxx.xxx, subnet mask and
gateway is the same with factory default
setup.
Network Camera factory default
setup
：
IP
：
192.168.1.108
；
Subnet mask
：
255.255.255.0
；
Gateway
：
192.168.1.1
Open system, you can see security alarm
interface asking you whether install
Network Camera web control
webrec.cab or not. Please click OK, you
can see system begins auto installation.
After logged in, you can modify default IP
address, subnet mask and gateway.
Factory default account is:
Username: admin
Password: admin
Please refer to chapter 4.2 for IE
setup modification if you can not
install controls properly.
After installation, you can enter the main
interface. Please input your user name
and password to login.
Open IE browser and then input Network
Camera address in the address column:
such as 192.168.xxx.xxx.
Use ping xxx.xxx.xxx.xxx (Network
Camera IP address) to check network
connection.
