iCanServer440R User’s Guide
y
System Name
It is the name of the iCanServer440R. It is same as the one set-up by IP-installer. You can
reassign the system name in admin mode
.
y
Audio Input Selection
-
Select the type of input audio for each channel. Line In is used for connecting audio
output from audio devices. Mic is used for connecting the output of microphone
.
-
Input Gain : Set the gain of the input audio
.
y
Video Quality & Bandwidth Control
-
Input Video Source : Select the analog video standard for input. Select one from NTSC, PAL,
SECAM.
-
Video Size : Select a video size for transmission. Allowed video size are different for each
video standard.
- NTSC(30 frames/sec Max.) : 176x144 / 320x240 / 640x240 / 640x480.
- PAL (25 frames/sec Max.) : 352x288 / 704x288 / 704x576.
- SECAM (25 frames/sec Max.) : 352x288 / 704x288 / 704x576.
z
Description : Assign name for each channel. Assigned names are shown on
corresponding view window of the viewer. The name consists of maximum 79
alphanumeric characters..
z
Max upload rate
Assign maximum bandwidth of the uplink for the network connected to
iCanServer440R.
z
Frame rate
Assign number of video frames transmitted for each second. You can improve picture
quality by lowering frame rate for the same bandwidth.
z
Video rate
Assign bandwidth for transmitting video data for each channel. Video data is not
transmitted if NA is selected.
z
Audio rate
Assign bandwidth for transmitting audio data for each channel. Audio data is not
transmitted if NA is selected.
- Enable High Quality Recording
z
Select this mode when your network is a low speed network that cannot assure
Rev.2.0 (Aug. 2004)
22
