Page 8
It is essential to ensure that the shackles or carabiners are firmly closed
after connecting the rescue to the paraglider harness.
Another fixing method is to put the belt of the rescue system through the
connection belt of the harness and than the rescue system through the harness
belt.
It is just as very important that the knot is very tightly fastened.
Therefore, use cable fixer, adhesive tape or strong rubber bands and pull it
above
and below the knot
around the belts.
Pay attention to the symmetry of both lines. Neither side of the loop must be
longer than the other.
Compatibility- check
A control of every new combination of rescue system and harness/outer container
must be carried out by either the producer of the harness or the rescue system or
an authorized person (dealer or flight instructor). The activation of the rescue
system in flight position must be correct and in conformity to the construction
guidelines.
The pulling force for triggering must not exceed 70N. The throwing
movement should be practiced under conditions that are as realistic as
possible each time the rescue system is repacked.
IMPORTANT POINTS TO LOOK OUT FOR:
Check (regularly)
•
connection of the rescue system to your harness
•
connection of the harness and deployment handle
•
the closing splint must be held with a special thread.
Packing line from the fixing loops is removed (after each packing)
Check compatibility of rescue system and harness
Before each start with your glider, you must check the container is closed!
Summary of Contents for SQUARE Light 90
Page 1: ...EN...
