36
ICC
8.7
Ethernet Protocol Configuration
The following section describes how to configure the Ethernet protocols on the
gateway with the configuration utility. For more details on how to use the
configuration utility, refer to the ICC Gateway Configuration Utility User’s Manual.
8.7.1
Ethernet Configuration Subtab
The Ethernet configuration subtab contains Ethernet-related configuration items
that are not specific to any given protocol. These settings should be
appropriately configured regardless of any Ethernet protocols that may be
enabled.
8.7.1.1
Authentication Group
Be sure to make a note of the new settings whenever these authentication
credentials are changed, as they must be entered whenever the web page is
accessed, an FTP session is initiated, or when a configuration change is
performed via the Finder tab. Contact ICC for assistance if you have forgotten
your customized credentials.
User Name
The username is case-sensitive and can contain letters (“a..z” and “A..Z”) and
numbers (“0..9”), and can be up to 80 characters in length.
Password
The password is case-sensitive and can contain letters (“a..z” and “A..Z”) and
numbers (“0..9”), and can be up to 80 characters in length.
8.7.1.2
Network Configuration Group
Configuration items used to modify the IP address-related parameters.
Modification of these settings is consistent with the technique used with the
Finder tab (refer to section 8.2).
