INSTRUCTION MANUAL
CODE 80300 REV C
09/2020
Page: 8
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
6. STARTING UP
6.1 Control panel
1. Stop / Start cycle Key
2. Reduce value key
3. Increase value key
4. Adjustment (change between temperature / time).
6.2 Starting up
1. With the equipment installed in the bucket, fill it with water to cover the pump
completely.
2. Press the start key, the display will light up and the pump will start to run.
3. Press the Up/Down keys (3/2) until the desired temperature value is selected
in the green display (the above one).
4. Press key (4) if you want to select an operating time.
5. Press key (1) to start the cycle.
6. The countdown time will start counting as soon as the set temperature will be
reached.
7. The heating symbol will light up and flash.
8. Press key (1) again to stop the process. Note: during operation, temperature or
time adjustment value can be changed.
9. When the time has expired, a beep will sound and the heating-element will stop
heating.
REMARKS:
* When using the time function, the green display (the above one) will indicate
the remaining time. If you want to see the target temperature value, press key
(4).
6.3 Safety thermostat
The equipment has a safety element to prevent overheating.
In case the thermostat triggers, press the rear button to reset the device.
4
3 2
1
