Serious Connections
TM
9
ICCONS™ GAS TOOL GT-3 & GT-3ST USER MANUAL
and release it gently.
4. For removing the pins, lock the
follower at the magazine bottom and
the pins will slide down. Further pull the
follower for releasing all the pins.
G. Driving the pins
Caution !
• Please READ and UNDERSTAND the
section “General Safety Instructions”
for personal and working
environment safety.
• If you spot of any abnormality about
the tool, contact nearest
authorized serviceman for
inspection and repairing.
Steps:
1. Press the Nose of the contact arm
against working surface (90° against
the surface) firmly until you hear the fan
motor is working.
2. Pull the trigger, the pins are driven
to the object.
3. Release the trigger and lift the tool.
H. Cleaning jam
Jamming of pins could be evident if
users cannot drive the fasteners
properly, try following steps in
subsequent order.
Caution !
• Place the tool on flat surface
prior to releasing the magazine,
(magazine may pop off suddenly).
• Read previous sections to fully
understand battery cartridge
installation/removal and unloading
fasteners.
Steps:
1. Remove the pins, fuel cell and
battery from tool
2. Pull down and lock the follower.
3. Pull the knob on the handle
connections, keep pulling and turn the
knob counter-clockwise, the magazine
will release.
4. Clean any residue along the driving
path in the nose piece and pin guide.
5. To install the magazine, first engage
the magazine in the slot of the nose
piece
6. Lock the magazine by pressing the
connector finger in the lock.
NOTE:
• Do not release the magazine with
fasteners inside. The follower may
pop the pins out and cause injury.
• Wear safety goggles, the jammed
fastener may jump out and hurt the
user.
