ICE COBOTICS i-SYNEGY i20NBTL+, Operator'S & Parts Manual

ICE /

10

OPERATOR MANUAL

WARNING: Before performing any 

maintenance on the machine, be sure that 

the power is turned off, or the batteries are 

disconnected!

           WARING: Repairs  are to be completed 
by Authorized service centers only. Any repairs 
completed by unauthorized persons will avoid 
the warrenty.

DAILY MAINTENANCE

1.  Remove pad driver/ brush and clean with 

approved cleaner.

2.  Drain recovery and solution tanks completely 

and rinse out with clean water. Visually check 
the recovery tank for debris and clean out as 
necessary.

3. 

Raise the squeegee assembly off floor and wipe 

it down with a damp towel. Be sure to store the 
squeegee in the up position.

4. 

Remove the float shut-off assembly and rinse it 

out with clean water.

5.  Clean machine with an approved cleaner and a 

damp towel.

6.  Recharge the batteries.
7.  Check the condition of the squeegee blade 

wiping edge, rotate blade if worn.

MONTHLY MAINTENANCE

1.  Clean the battery tops to prevent corrosion.
2.  Check for loose battery cable connections.
3.  Inspect and clean the recovery tank cover seal. 

Replace it if damaged.

4.  Lubricate all grease points and pivot points with 

silicon spray and approved grease.

5.  Check the machine for loose nuts and bolts.
6.  Check the machine for leaks.

ORBITAL HEAD MAINTENANCE

For Orbital head, you should have checked the 
eight isolators located in the Orbital head every 300 
hours. 
1. 

Using a flashlight, do a visual inspection of the 

isolators by looking through the opening in the 
Orbital head and checking for wear or damage 
to four isolators in the front and four in the rear 
of the Orbital head. The locations of the isolators 
are show below. 
 

2.  If any of the eight isolators show signs of wear, 

degradation or damage, contact your local 
distributor to replace all eight isolators.

MACHINE STORAGE

1.  Always store the machine indoors.
2.  Always store the machine in a dry area.
3.  Always store the machine in its upright position.
4.  Always store the machine with the pad driver/ 

brush raised off the floor.

5.  Always store the machine with the squeegee 

assembly raised off the floor.

6.  If storing in an area which may reach freezing 

temperatures, be sure to drain all fluids from the 

machine prior to storage. Any damage caused by 
freezing temperatures will not be covered by the 
warranty.

7.  Drain the recovery tank.
8. 

Drain the solution tank of all fluid.

PREVENTATIVE MAINTENANCE