PAGE
2
OF
4
STEP 4:
•
INSERT ALL THE SMALL TUBES INTO THE SIDE
OF THE BRACKET MARKED “
SMALL
TUBE”.
•
DO THIS FOR ALL THE SMALL TUBES.
STEP 5:
•
YOU SHOULD NOW HAVE FOUR COMPLETE
SIDES.
*
MODEL SHOWN IS FOR REFERENCE ONLY, SIZING
WILL VARY DEPENDING ON THE KIT SIZE
PURCHASED.
STEP 6:
•
AT EACH CORNER INSERT A FLEXIBLE FOAM
FITTING INTO EACH END.
•
USE A TWISTING MOTION FOR BEST RESULTS.
STEP 7:
•
ENSURE THAT YOUR FRAME IS SQUARE BY
MEASURING FROM CORNER TO CORNER. BOTH
MEASUREMENTS SHOULD BE APPROX. THE
SAME VALUE.
•
PLEASE SEE THE CHART ON OUR WEBSITE FOR
THE DIAGONAL MEASUREMENT FOR YOUR
RINK SIZE.
*
