Maintenance
CD40030/CD40022
Page
14
Spilled ice and user debris will collect in the ice catch pan, located just below the sink grill.
Occasionally the debris will need to be removed and the drain flushed out to prevent water
back ups.
Note: Failure to clean out the ice catch pan will likely result in a water leak, one that is NOT
covered by warranty.
To clean out the ice catch pan:
1. Disconnect electrical power.
2. Remove the two screws holding the top panel to the
dispenser. Lift the top panel up and off the dispenser.
3. Pull the top edge of the front panel forward until
the two snaps disengage.
If the unit is a coin op model, reach
behind the front panel and disconnect the
coin mechanism harness from the front
panel.
If the unit is a water dispenser model,
reach behind the front panel and shut off
the water supply valve to the water faucet.
Then disconnect the water line from the
shut off valve.
4. Remove the front panel.
5. Pull the ice catch pan forward a few
inches until the drain hose can be
reached.
6. Pull the drain hose from the ice catch pan.
7. Slide the ice catch pan out of the ice
dispenser and clear it of any debris. Wash
out the drain.
8. Return the ice catch pan to its normal
position.
9. Re-attach the drain hose.
10. Reassemble and connect
power.
