ELEVATION SERIES CIM CUBERS
EVAPORATOR REPLACEMENT
57
On the rear of the evaporator assembly, disconnect harvest assist assembly, purge valve and purge tube
and remove from the unit. Note there are two harvest assist, one for each plate. Make sure you
disconnect the proper one.
Once all the refrigerant is recovered. Remove the foam insulation from the evaporator plate tubing and
Un‐braze the evaporator tubes from the system so the plate is disconnected from the tubing system.
Remove the three ¼” screws along the back side of the evaporator holding it to the base in the machine
compartment.
Rear Mounting
Screws
Insulation to be
removed and
tubes un-brazed
Harvest Assist
Purge Vavle
Purge Tube
Summary of Contents for CIM Series
