Ice i20NBT, Operator'S & Parts Manual

6

ICE i20NB / i20NBT / i20NBT-OB / i24BT

OPERATOR MANUAL

UNCRATING MACHINE

Be sure and check packing carton for any damage. 

Immediately report any damage to carrier. Check 

the contents of package to ensure that the 

following items are included: 

•  Machine

•  2-12V Batteries

•  Squeegee assembly

•  Battery Charger

•  Pad Driver

•  Brush

INSTALLING BATTERIES

The batteries are already in the machine upon 

delivery; However you will need to connect the 

cables to the battery posts.

  WARNING: Batteries emit hydrogen gas.

Explosion or fire can result from hydrogen 

gas.Keep sparks and open flames away! Keep 

battery compartment open when charging.

1.  Turn the main power key switch off.

2.  Open recovery tank to gain access to battery 

compartment.

3.  Carefully place the two batteries into the 

compartment as shown in figure below. Place 

the battery brace at the rear of the two batteries. 

DO NOT DROP BATTERIES INTO 

COMPARTMENT!

4.  Connect battery cables to posts in numbered 

order as shown in drawing below.  

RED to POSITIVE and BLACK to NEGATIVE.

MACHINE SET UP

PRE-OPERATION CHECKS

1.  Sweep or dust mop the surface to be cleaned.

2.  Check battery meter to make sure batteries are 

fully charged. (See BATTERY CHARGING)

3.  Check that squeegee is properly installed.

4.  Check that brush / pad is properly installed. 

INSTALLING PAD DIVER OR BRUSH

1.  Ensure that the machine is turned off.

2.  Step down on the scrub head lift pedal (see 

machine components, item #16) to raise the 

scrub head off the floor.

3.  If using a Pad Driver, first attach the appropriate 

pad to the pad driver surface.

4.  Turn the brush motor hub until the slot with the 

spring clip is visible through the scrub head 

window.

5.  Mount the pad driver or brush to the brush 

motor hub by lining up the three studs with the 

three holes in the brush motor hub. Once in the 

holes, rotate the driver toward the spring clip to 

lock the pad driver into place. 

If necessary, press down on the motor hub lock 

pin (see machine componts, item # 41)to lock 

motor hub in place.

6.  For Orbital head Model i20NBT-OB, you need to 

attach a rectangular, 20in(508mm)×14in(356mm) 
Pad to the Orbital Pad driver. align the pad to the 
Orbital pad driver, press from front-to-back and 
side to side to alignment.

MOUNTING THE SQUEEGEE ASSEMBLY

1.  Lift the squeegee lift lever (see machine 

components, item #27)to the upward position.

2.  Mount the squeegee assembly to the squeegee 

pivot bracket. make sure the knobs are 

completely seated into the slots before securing 

knobs.

3.  Connect the vacuum hose to the squeegee 

assembly. Loop the hose by using the hose clip 

provided.

4.  Check the squeegee blades for proper 

adjustment.

MACHINE SET UP & INSTALLATION