ICE iS1100L
15
OPERATOR
MACHINE OPERATION
WARNING! Pay careful attention when operating the machine at high speed: sudden
steering could cause this three-wheel machine to become unstable due to weight
distribution.
Always reduce the speed before steering.
1) Avoid stopping for a long time with the machine in the same position and the brushess turning: this could create
2) To collect light and bulky waste materials, lift the front skirt by
pressing the pedal (3); take into consideration
that the machine vacuum capability is reduced when the front skirt is lifted.
While working, repeat the procedure every 15 minutes on average (depending on the dustiness of the area to be
cleaned).
NOTE:When the dust filter is clogged and/or the hopper is full, the machine
cannot collect dust and debris anymore.
4) The hopper (28) should be dumped after each working period and whenever it is full (see the procedure in the
next paragraph).
HOPPER EMPTYING
1) Stop the machine on a level surface by releasing the drive pedal.
3) Disengage the hook (29) by pulling its lower end.
5) Remove the hopper (28) by using the handle (30) and by disengaging it from the inner guides.
To move the hopper (28) by using the handle (30).
Discharge all the debris into special containers. To make discharging procedure easier, inside the hopper there are
6) Install the containers with handle (38), if equipped.
7) Install the hopper (28) and engage it to the inner guides, then fasten it with the hook (29).
8) The machine is ready to start sweeping again.
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
1) Lift the side brushes with the lever (69).
2) Lift the main brush with the lever (72).
4) Empty the hopper (28) (see the procedure in the previous paragraph).
5)
(71).
PUSHING/TOWING THE MACHINE
MACHINE STORAGE
If the machine is not going to be used for more than 30 days, proceed as follows:
1) Check that the machine storage area is dry and clean.
2) Disconnect the battery connector (44).
FIRST PERIOD OF USE
-Check the fastening and connecting parts for proper tightening.
-Check the visible parts for integrity and leakages.
Summary of Contents for iS1100L
