ICE iS1100L
19
OPERATOR
S I D E B R U SH H E I G H T C H E C K A N D
ADJUSTMENT
1) Check the side brush distance from the floor,
according to the following procedure:
-Drive the machine on a level ground and lower the
side brushes.
-Keep the machine stationary and turn on the side
brushes for a few seconds.
-Lift the side brushes, then move the machine and
-Check that the side brush prints are as shown in
If the print is not within specifications, adjust the
brush height, according to the procedure shown in
step 2.
2) T
.
3) Loosen the knob (A, Fig. 7) positioned above the
brush.
4) Turn the knob (B, Fig. 7) and remind that:
-It must be screwed to lift the brush;
-It must be unscrewed to lower the brush.
After the adjustment, hold the knob (B) and tighten
the knob (A).
5) Perform step 1 again to check the proper adjustment
of the side brush height.
6) When the brushes are too worn and can no longer
be adjusted, replace them according to the procedure
shown in the relevant paragraph.
SIDE BRUSH REPLACEMENT
CAUTION! It is advisable to wear protective gloves
when replacing the side brushes because there
can be sharp debris between the bristles.
1) Drive the machine on a level ground and
release the
pedal (2) and stop the machine.
2) T
.
3) Release the spring (A,Fig. 8),remove the pin (B) and
the brush (C) from the gearmotor shaft.
4 ) Ins ta ll th e n ew s id e b ru sh o n th e g ea rmo to r
shaft,insert the pin (B, Fig. 8) in the holes (D, Fig. 8),and
engage the spring (A, Fig. 8)
5) Check and adjust the side brush height as shown in
the previous paragraph.
NOTE:Brushes with harder or softer bristles are
available. This procedure is applicable to all types of
brushes.
NOTE:Brushes with harder or softer bristles are
available. This procedure is applicable to all types of
brushes.
Figure6
Figure7
Figure8
Summary of Contents for iS1100L
