Ice RS28-OB, Operator'S & Parts Manual

10

ICE RS26 / RS28-OB / RS32

OPERATOR MANUAL

BATTERY CHARGING

PREVENTATIVE MAINTENANCE

TANK DRAINING

DRAINING THE RECOVERY TANK

$Q\WLPHVFUXEELQJLVFRPSOHWHGRUZKHQUH¿OOLQJ

solution tank, the recovery tank should be drained 

and cleaned.

          WARNING: If the recovery tank is not 

GUDLQHGZKHQWKHVROXWLRQWDQNKDVEHHQ
UH¿OOHGIRDPRUZDWHUPD\HQWHUWKHÀRDWVKXW

off screen and cause damage to the vacuum 

motor.

1. While holding the Recovery tank drain hose 

(machine components, #40) upward, remove 

the cap and lower hose to drain.

2. Open the Recovery tank cover (machine 

components, #18)  and rinse out the tank. Use 

a rag to remove any excess dirt. Clean the 

YDFXXPIDQLQOHW¿OWHUORFDWHGLQWKHUHFRYHU\

tank .

DRAINING THE SOLUTION TANK

Any time scrubbing operation is completed, the 

solution tank should be drained and cleaned.

1.  While holding the Solution tank drain hose 

(machine components, #41) upward, remove 

the cap and lower hose to drain.

2.  Rinse the solution tank with clean water after 

every use.  This will help prevent chemical 

buildup and clogging of the solution lines.

           WARNING: Fire Or Explosion Hazard.

Batteries Emit Hydrogen Gas. Keep Sparks and
Open Flame Away. Keep Battery Compartment
Propped Open When Charging.
 

8

se on

O

y apprved chargers 

Z

ith the fo

OO

o

Z

ing 

speci

¿

cations:

‡

Automatic shut off circuit

‡

Deep cycle charging

‡

Output current of 20-30 Amps

‡

Output voltage of 24 volts

ON-BOARD BATTERY CHARGER

$VVWDQGDUGFRQ¿JXUDWLRQWKHPDFKLQHLVHTXLSHG

with the On-board battery charger. The settings 
of On-board battery charger had been set for the 
recommended batteries type. 

           WARNING:

7KH2QERDUGEDWWHU\

FKDUJHUVHWWLQJVFKDQJHDUHWREHFRPSOHWHG
E\DXWKRUL]HGVHUYLFHFHQWHUVRQO\)DLOXUH
WRSURSHUO\VHWZLOOUHVXOWLQWKHEDWWHULHVRU

charger damage. 

1.  Transport the machine to a well ventilated area.
2.  Turn the machine off.
3.  If charging wet (lead acid) batteries check the 

ÀXLGOHYHOEHIRUHFKDUJLQJ

4.  Prop up the Operator seat by the support stand 

for ventilation.

5.  Connect the charger's AC power supply cord to 

a properly grounded receptable.

6.  The charger will automatically begin to charge, 

you can watching the charging status on the 
window (machine components, #7), once the 

charging cycle begins, the indicator lights will 
progress from red, yellow to green. when the 
green indicator light comes on, the charging 
cycle is done. Unplug the charger cord.  

NOTE: The machine 

Z

i

OO

 can not operate 

Z

hen charging. 

WARNING: Before performing any 

PDLQWHQDQFHRQWKHPDFKLQHEHVXUHWKDW
WKHSRZHULVWXUQHGRIIRUWKHEDWWHULHVDUH

disconnected!

:$5,1*5HSDLUVDUHWREHFRPSOHWHG
E\$XWKRUL]HGVHUYLFHFHQWHUVRQO\$Q\UHSDLUV
FRPSOHWHGE\XQDXWKRUL]HGSHUVRQVZLOODYRLG

the warrenty.

DAILY MAINTENANCE

1.  Remove pad driver/ brush and clean with 

approved cleaner.

2.  Drain recovery and solution tanks completely 

and rinse out with clean water. Visually check 
the recovery tank for debris and clean out as 
necessary.

3. 

5DLVHWKHVTXHHJHHDVVHPEO\RIIÀRRUDQGZLSH

it down with a damp towel. Be sure to store the 
squeegee in the up position.