37
WORK
As soon as the dead man's levers are pressed the traction motor,
brush head motor and vacuum motor will start working. As a result,
the solenoid valve will also begin working and detergent solution will
be delivered to the brush.
During the first few metres, check that there is sufficient solution and
that the squeegee is drying correctly.
The appliance will now begin to work with full efficiency until the
battery is flat or until the detergent solution has finished.
ATTENTION:
If the dead man's levers are released during the
work the appliance will stop moving froward, the brush motor
and the solenoid valve will stop working, while the vacuum
motor will keep working for a set period of time (factory setting
is fifteen seconds) and the symbol (4) will start flashing until
the vacuum motor switches off.
ATTENTION:
If the appliance has to be switched off with the
brush head and the squeegee unit still in contact with the floor,
when switched on the work display will show the symbols (3)
and (5), indicating that when it was switched off it was carrying
out scrubbing with drying (
Fig.5
).
ATTENTION:
If, during work, there is the need to exert more
pressure on the brushes (versions with PM) simply press the
"BRUSH HEAD COMMAND" button (2) on the control panel
(
Fig. 2
) for more than three seconds, the command display
shows the symbol (9) (
Fig.9
).
ATTENTION:
If, during work, there is the need to return to
working without exerting more pressure on the brushes
(versions with PM) simply press the "BRUSH HEAD
COMMAND" button (2) on the control panel (
Fig. 2
) for more
than three seconds, the command display shows the symbol
(3) (
Fig.5
).
SCRUBBING WITHOUT DRYING (traction version)
To carry out “SCRUBBING WITHOUT DRYING” tasks, proceed as
follows:
1. Make all the checks indicated in “
2. For traction version, lower the brush head unit by pressing the
brush head control pedal (1) on the back of the appliance (
Fig.1
).
3. For the PM versions, lower the brush head unit, press the
“BRUSH HEAD COMMAND” button (2) on the control panel
(
Fig.2
).
ATTENTION
:
As soon as the brush head unit is removed from
the rest position the control display shows the symbol (3)
(
Fig.3
).
ATTENTION:
When the symbol (3) is shown on the control
display it means that the work being carried out is
“SCRUBBING WITHOUT DRYING” (
Fig.3
).
4. Pull the knob (4) down and adjust the amount of solution desired
(
Fig.4
).
ATTENTION:
by pulling the detergent solution flow adjustment
knob downwards, the amount of solution in the water system
will increase (
Fig.4
).
5. Adjust the dead man's levers (5) on the instrument panel (
Fig.5
).
ATTENTION:
The appliance has two forward speeds. By
pushing the dead man's levers beyond the first CLICK the
“
SLOW
” speed is activated, continuing to push the levers
beyond the second CLICK the “
FAST
” speed is activated.
7. Set the required forward speed by turning the knob (6) gradually
to the right (
Fig.6
).
ATTENTION:
For adjustments to the forward speed read the
paragraph “
ADJUSTING THE FORWARD SPEED (BT
”.
3
3
5
5
3
1
2
1
2
6
4
6
4
5
5
3
7
8
7
8