42
AT THE END OF THE
WORK
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
7. For traction version, lower the brush head unit by pressing the
brush head control pedal (1) on the back of the appliance (
Fig.1
).
8. For the PM versions, lower the brush head unit, press the
“BRUSH HEAD COMMAND” button (2) on the control panel
(
Fig.2
).
9. Raise the squeegee unit and turn the squeegee control lever (3)
in the direction of the arrow in (
Fig.3
). The lever is located on the
back of the device.
10. Take the appliance to the dedicated waste water drainage area.
11. For 50D version, switch off the appliance by pressing the main
switch (4) on the back of it (
Fig.4
).
ATTENTION:
the main switch (3) is in the idle position when
the LED inside it is OFF and the activation symbol is not
visible.
12. For traction version, make sure the device is switched off. If it
isn't, set the main switch (5) to “0” by turning the key (6) a quarter
turn to the left (
Fig.5
). Remove the key from the instrument panel.
13. Carry out all the procedures listed in the paragraph
RECOMMENDED PERIODIC MAINTENANCE
” indicated in the
column “AT THE END OF THE WORK”.
14. Take the appliance to the designated storage area.
ATTENTION:
park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.
15. Take all the necessary steps to ensure that the device is in a safe
condition (see "
’”).
ATTENTION:
if the appliance is not used for more than a day,
remove the brush from the brush head unit, read the
paragraphs “
CHECKING AND CLEANING THE BRUSH (B
CHECKING AND CLEANING THE BRUSH
,
the squeegee unit from the squeegee
support read the paragraphs “
”.
AT THE END OF THE WORK
6
4
5
4
5
OFF
1
3
3
1
2
2
