Torus 126, 380 and 500
Operator Manual
4-2 Turn on the Printer
Rev AB
The sequence of steps that occur after you turn on the printer are as
follows:
1
During the startup sequence, the printer performs a number of self-
diagnostic checks. These checks take approximately 90 seconds to
complete.
2
During the self-diagnostic checks, the CLARiTY™ interface screen
shows the first set of diagnostic data. Ignore this data.
3
When the self-diagnostic checks are complete, the CLARiTY™
Home
Page
appears (refer to Figure 4-2).
4
The status window of the
Home Page
shows the
SHUTDOWN
status.
5
During the
SHUTDOWN
status, the
Stop
(red) and
Run
(green)
buttons (Figure 4-2) are disabled (in grey color).
Note:
If the print sensor is activated accidentally, the printer will not operate
because all the sensor and encoder input are ignored during the shutdown
status.
Note:
During the shutdown status, make sure that the production line and
printer are prepared and ready for the shutdown.
Figure 4-2: Home Page
Stop(red)
Run(green)
Shutdown
Shutdown Status
