Zodiac Plus Operator Manual
Rev AA
Changing the Position or Appearance of the Print 4-19
4
Select the Print Delay parameter to open the print delay
parameters setup.
5
Enter a new value using the keyboard.
6
Touch OK to save the parameter settings.
7
Touch the Home button to return to the home page.
Setting the Print Speed
Note:
This feature can be applied only on intermittent mode applications.
The thermal transfer ribbon used by the printer adheres more readily
to some types of packaging materials than others. The print speed can
be reduced to improve the bonding and print quality, and increased to
achieve greater throughput in terms of packs per minute, by reducing
the overall print cycle time.
To change the print speed, proceed as follows:
1
Touch the Tools button on the home page.
2
Touch the Setup button on the tools page.
3
Touch the Printhead button to open the printhead setup page.
4
Touch the Print Speed button to open the print delay setup page.
5
Enter a new value using the keypad.
6
Touch the Home button to return to the home page.
Setting the Printhead Position
Note:
This feature can be applied only on continuous mode applications.
When printing continuously, the printhead will press the target
material down against the roller, as shown in Figure 4-17.
1. Printhead
2. Target Material
3. Roller
4. Printhead Position Adjustment
Figure 4-17: Printhead Print Position
4
2
3
1
