Zodiac Plus Operator Manual
4-20 Changing the Position or Appearance of the Print
Rev AA
You can change the angle of the printhead against the target material,
by changing the printhead position. This angle affects the print
quality. If the angle is not suitable, the resulting print may appear
faded.
To find a suitable printhead position, proceed as follows:
1
Touch the Tools button on the home page.
2
Touch the Setup button on the tools page.
3
Touch the Printhead button to open the printhead setup page.
4
Touch the Print Position button to open the print position
parameters setup page.
5
Enter a new value using the keypad.
Note:
You should change the print position parameters in steps of 1 mm.
The print position parameter is in 0.01 mm units, so a change of 100
units will move the printhead by 1 mm.
Examine the sample prints from each position until you find the
optimum print quality at the required print speed.
6
Touch the Home button to return to the home page.
Setting Interleaved Printing
This feature allows you to select a lower ‘draft’ quality print mode
which halves the ribbon consumption of the machine.
To set to interleaved printing mode, proceed as follows:
1
Touch the Tools button on the home page.
2
Touch the Setup button on the tools page.
3
Touch the Printhead button to open the printhead setup page.
4
Touch Interleaved Images and select yes to switch this feature on,
no to turn it off.
5
Touch the Home button to return to the home page.
