IceCure Medical Ltd.
DSR3000000 rev.L
Confidential
User Manual
69
IceSense3™
Figure 58: Warm screen in Manual Mode
During the manual procedure the system provides information regarding treatment progress:
The left side of the screen displays the Current Step (freeze, thaw or warm cycle) and time
elapsed for this specific step.
The right side of the screen displays information on the entire Protocol as total elapsed time
and treatment format.
If you perform more than 3 consecutive freeze/thaw cycles, the right side will only display the
last 5 actions due to screen size limitation (3 freeze thaw cycles).
5.3.5.1
Automatic freeze mode
Choosing one of the suggested protocols from the Treatment Selection screen will open the
automatic protocol screen.
To activate the freeze/thaw preprogrammed cycles, press the Action button on the
cryohandle and hold it for one second or press the “Freeze” icon on the left lower corner of
the screen. The
BLUE
LED will light up around the Action button.
The “start” icon will change to a “Skip” icon.
The skip icon enables the user to skip from the current step in the cycle to the next step as
preprogrammed.
Within a given protocol, if you want to increase/decrease the preprogrammed time of a cycle
when the cycle has already started, use the +/- icons on the left side of the screen to
add/subtract 15 seconds with each push.
At the end of the last freeze step in automatic mode, the Warm step will begin and the Warm
screen will be displayed.
