Iceking HZ552SE, Installation And Operating Manual

Section 1. Installation 

-

IMPORTANT! 

This appliance must be left to stand in an upright position for

at least 4 hours before being switched on for the first time.

-

Remove all packaging and securing tape from the appliance.

-

Wash the interior of the appliance with luke warm water containing a small
amount of bicarbonate soda (5ml to 0.5 litres of water).

-

Position the appliance in a dry atmosphere and out of direct sunlight.

-

Do not position next to a cooker or other sources of heat, i.e. radiator.

-

If positioned next to another fridge or freezer, leave a minimum gap of 2cm
between the appliances in order to avoid condensation.

-

A clearance of 50mm should be left above the appliance.  If this cannot be
achieved you should ensure a clearance of 25mm is maintained on each
side of the appliance.

-

Please ensure that there is a small ‘air-gap’ between the condenser on the
rear of the appliance and the rear wall.

-

Do not place or store heavy items on the top of this appliance.

-

Ensure that the appliance is positioned on a firm flat floor.

-

This appliance must be level.  Adjust the level by screwing the adjustable
feet up or down (use your fingers or a suitable spanner).

-

Ensure that the appliance is upright and both feet are in firm contact with
the floor so that the cabinet is stable.

-

Connect the plug to an adjacent 13amp socket outlet and ensure that the
appliance is not standing on the supply cable.

7