Before Using Your REFRIGERATOR
Remove the exterior and interior packing.
Before connecting the refrigerator to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Check to be sure you have all of the following parts:
3 Bottle holders
3 Glass Shelves
1 Crisper
1 Instruction Manual
Clean the interior surface with lukewarm water using a soft cloth.
SPACE REQUIREMENTS
WARNING: KEEP flammable materials and vapors, such as gasoline, away from refrigerator
Failure to do so can result in death, explosion, fire or burns.
To ensure proper ventilation for your refrigerator, allow for 200mm space on each side between
walls 200mm space between back of your refrigerator and the wall, and 300mm space between
counter top and the top of the appliance.
If you are installing your refrigerator next to a fixed wall, leave sufficient space on the hinge side
to allow for the door to swing open
Never install your refrigerator near a heat source or direct sunlight.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE EARTH CABLE
DO NOT USE AN ADAPTOR
DO NOT USE EXTENSION CORD
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you have the
proper electrical connection
Recommended Earthing Method
A 220~240 Volt/50 Hz AC only 10 ampere fused and properly earthed electrical supply is
required .it is recommended that a separate circuit serving only this appliance be provided .Use a
socket which ideally cannot be turned off with a switch or pull chain. Do not use an extension
cord.
NOTE: Before performing any type of installation, disconnect the refrigerator from the electrical
source. When you are finished, connect the refrigerator to the electrical source and reset the
control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation .The doors may not close or seal properly,
which causing cooling, frost or moisture problems. It is very important for the refrigerator to be
leveled in order to function properly
To level your refrigerator you may either turn the level leg clockwise to raise that side of the
refrigerator or turn counter-clockwise to lower that side.
