Iceking RZ204W.E, Installation And Operating Manual

4.5. Reversing the Door

The door opening can be reversed from “right hand hinged” to “left hand hinged” if 
required. If your appliance is supplied “left hand hinged” simply reverse the 
following procedure.

Warning!
When reversing the door, the appliance must not be connected to the mains.
Remove the plug from the mains beforehand.

Remove the top hinge cover
Lean the appliance back and prop it up securely at the front
Remove the top door hinge screws and remove the hinge bracket 
Remove the door from the lower hinge
Now remove the lower hinge bracket and unscrew/remove the central 
hinge pin. Turn the hinge over and refit the hinge pin as shown below

Secure the lower door hinge into place on the opposite side of the 
appliance
Now ensure both levelling feet are in place and secure 
Now position the door onto the lower hinge bracket
Now refit the upper hinge bracket on the opposite side of the appliance
Do not fully tighten the screws until you have tested that the door closes 
correctly and that the door seal is tight
Now secure all the screws
Refit the top hinge cover.

N.B. Service calls relating to door problems and/or cooling issues will be 

chargeable if the fault is found to be due to an incorrect door 
reversal procedure carried out by the consumer!

14