13
Installation
Door Reversal Instructions
If you require the door to be reversed it is advisable to do so before anything is
placed inside the fridge or switched on. If the appliances is placed on its back for a
prolonged period of time during this process, it must be allowed to remain upright for
6 hours before turning it on to avoid damage to the internal components.
To reverse the door follow the below directions
•
Remove the plastic hole cover located on
the
top left side of the refrigerator as shown
in
Fig.1
.
•
Remove the upper hinge cover and the
upper
hinge on the right side of the
refrigerator, as
shown in Fig.2.
•
Remove the door from the lower hinge pin
by
pulling it gently upwards. Remove the
lower
hinge bracket on the right side of the
unit and
remove the leveling foot on the left
side.
Reverse their positions as shown in
Fig.3.
•
Install the lower hinge on the left side of the
refrigerator. Install the adjustable foot on the
right side of the refrigerator as shown in
Fig.4.
•
Move the door bushing to the left and the
plastic hole cover to the right as shown in
Fig.5.
•
Remove the door stop from the lower right
hand side of the refrigerator door. Install the
door stop on the lower left side of the
refrigerator door as shown in Fig.6.
•
Install the upper hinge and hinge cover
cover
on the left side of the unit. Place the
plastic
hole covers in the holes on the right
side of
the top of the refrigerator to cover
the screw
holes as shown in Fig.7.
Note: When installing the door, ensure that the top of the door is level with the
top of the cabinet. If the door is not level the rubber gasket will not make a good
seal with the cabinet which can cause the appliance to malfunction.
