ICE TECH SS / SP Technical Service
Manual
16
WARNING: DO NOT LEAVE PACKING MATERIALS (PLASTIC BAGS, CARDBOARD
BOXES, ETC.) WITHIN REACH OF CHILDREN.
4. INSTALLATION
The ice cube maker is delivered on a small wooden pallet and is protected with a cardboard box and
packaging. Loosen the cardboard box by cutting the straps, then lift vertically.
After having removed the packaging, make sure the machine is complete. If in doubt do not use it
and go to the distributor who sold it to you.
This operation has to be performed with the wooden base structure firmly placed on the ground. All
packaging elements (plastic bags, cartons, etc.) must not be left at children's reach, since they are
a potential source of danger.
Place the machine where it is to be installed, and verify, using a level control, that the machine is in
a horizontal position.
IMPORTANT!
If the gap between the back of the machine and the wall of the room/bar is not sufficient, or if it is
going to receive hot air from another machine, we strongly advise you, in case of not being able to
change the location of the machine, to INSTALL A WATER-COOLED MACHINE.
